![]() Good morning sonofdbn, here is a discussion that you might find useful: Is something else required in order to enable UPnP? (And is that the likely problem?) So I think I misunderstood what is required. It was suggested there that Bridge mode should be used for Network Type, so I tried that, but it seems to remove (or not require) any port mapping then. I read a thread here on the Logitech Media Server docker which mentioned a similar-sounding UPnP problem. I'm wondering if the problem is with UPnP (which I know very little about) and whether it somehow needs to be enabled on unRAID. ![]() (I tried shutting down the Syno server and reinstalled MinimWatch, but that didn't help.) But I couldn't get it to find the docker MinimServer. I installed it, and it had no problem finding a MinimServer test server that I was running on a Synology NAS. MinimServer is controlled via MinimWatch, which can be installed on a Windows PC. The problem was that I couldn't access it from any PC on my network. It required going to MinimServer's http page and accepting a licence agreement, but after that it seemed to be OK, as its web ui said it was running (and the log showed this as well). Somewhat to my surprise (and a testimony to the amount of information available here), I managed to get MinimServer running. ![]() I haven't done a "manual" docker install before, but after a bit of reading I managed to download it via the CA tab and fiddled around mapping paths and ports, and in particular setting Network Type to "Bridge". MinimServer is a UPnP music server I'm trying to install a MinimServer docker ( ). ![]()
0 Comments
Leave a Reply. |